管家婆免费资料大全

你好,欢迎来到管家婆免费资料大全官方网站!

沼气发电机组水箱中的冷却液如何检查

来源:   发布于:2020-01-14

  1.对新启动的沼气发电机组进行冷却或检修后对较好的二次发动机进行冷却。

  1. Cool the newly started biogas generator unit or cool the better secondary engine after maintenance.

  2.检查天然气发生器的所有排水开关是否关闭。

  2. Check whether all drain switches of natural gas generator are closed.

  3.打开恒温器阀座上的阀门开关。

  3. Open the valve switch on the thermostat seat.

  4.水箱的散热器慢慢加入冷却剂,为了排除管道内的空气,当没有气泡出阀时,关闭阀门开关。

管家婆免费资料大全_ 沼气发电机组

  4. Slowly add coolant into radiator of water tank. In order to eliminate air in pipeline, close valve switch when there is no bubble coming out of valve.

  5.继续向散热器加注冷却液,直至散热器液位高于散热器散热片液位(距离水箱顶部约10~20mm)。

  5. Continue to fill the radiator with coolant until the radiator level is higher than the radiator radiator level (about 10 ~ 20mm from the top of the water tank).

  6.检查天然气发生器水箱散热器表面缝隙是否有堵塞,必要时及时清理。

  6. Check whether the gap on the radiator surface of the water tank of the natural gas generator is blocked, and clean it in time if necessary.

  打开如果它是一个沼气发电机组或发动机修理后,检查完成后,启动引擎运行恒温器完全打开,停止,冷却液体冷却,打开盖子检查散热器的水箱液位高度,检查油位油标尺标记,冷却剂,石油是不够及时添加。

  Open if it is a biogas generator set or engine repair, after the inspection, start the engine to run the thermostat to fully open, stop, cool the liquid, open the cover to check the water tank level of the radiator, check the oil level scale mark, coolant and oil are not added in time.


上一篇:区分有刷电机和无刷电机,解决油泵问题
下一篇:最后一页

管家婆免费资料大全-管家婆马报彩图大全-管家婆全年资料大全
Baidu
sogou